XC6416 Series

200mA Dual High Speed LDO Voltage Regulator with “GreenOperation”

The XC6416 series is a high accurate, low noise, high ripple rejection, and low dropout CMOS Dual regulator with GreenOperation function. The series includes a reference voltage source, an error amplifier, a current limiter, and a phase compensation circuit.

GreenOperation function provides high speed operation, low power consumption and high efficiencies by automatically switching between a high speed mode (HS) and a power save mode (PS) depending on the load current level. The switching point of the GreenOperation to the output current is being fixed inside the IC, thus providing operating conditions with the most suitable level of quiescent current for the application. The USP-6C package has GO pin. If a high level singal is input to the GO pin, the XC6416 can be used as a high speed fixed mode regulator.

The EN function turns each output of the two regulators independently. In this state, the electric charge at the output capacitor (CL) is discharged via the internal auto-discharge switch, and as a result the VOUT voltage quickly returns to the VSS level. The output stabilization capacitor (CL) is also compatible with low ESR ceramic capacitors. Output voltage is selectable in 0.05V increments within a range of 0.8V ~4.0V, using laser trimming technologies.

The series includes a fold-back circuit, which aids the operation of the current limiter and circuit protection.

Typical Application Circuit

Features

Output Current 200mA(300mA limit)
Dropout Voltage 95mV@IOUT=100mA(VOUT(T)=3.0V)
Operating Voltage Range 1.5V~6.0V
Output Voltage Range 0.8V~4.0V(0.05V increments)
High Accuracy VOUT≧2.0V(±1%),VOUT≦1.95V(±0.02V)
VOUT≧1.5V(±2%),VOUT≦1.45V(±0.03V)
VOUT≧2V(±3%),VOUT≦1.95V(±0.06V)
Low Quiescent Current TYP.5.0μA/ch(PS),TYP.28μA/ch(HS)
Stand-by Current Less than 0.1μA
High Ripple Rejection: 60dB@1kHz
Operating Ambient Temperature -40℃~85℃
Low ESR Capacitor 1.0μF Ceramic Capacitor Compatible

Packages

DATA SHEET

Quality Reports

FAQ

QuestionWhat is the standby current?
Answer

The current that flows through the IC in the standby mode. The standby mode means the state where the IC has been turned off by the CE function.

Close