XC9504 Series

2ch. Step-Up / Inverting DC/DC Controller

The XC9504 series are PWM control, PWM/PFM switching, 2 channel (step-up and inverting) DC/DC controller ICs.

With 0.9V of standard voltage supply internal, and using externally connected components, the output 1 voltage (step-up DC/DC controller) can be set freely within a range of 1.5V ~ 30V. Since output 2 (inverting DC/DC controller) has a built-in 0.9V reference voltage (±2.0%), a negative voltage can be set with the external components.

With a 180kHz frequency, the size of the external components can be reduced. Switching frequencies of 300kHz are also available as custom-designed products.

The control of the XC9504 series can be switched between PWM control and PWM/PFM automatic switching control using external signals. Control switches from PWM to PFM during light loads when automatic switching is selected and the series is highly efficient from light loads through to large output currents. Noise is easily reduced with PWM control since the frequency is fixed.

The series gives freedom of control selection so that control suited to the application can be selected.

Soft-start time is internally set to 10ms (output 1) which offers protection against rush currents and voltage overshoot when the power is switched on .

Typical Application Circuit

Features

2chDC/DC Controller Output 1: Step-down DC/DC Controller,Output 2 : Inverting DC/DC Controller
Output Voltage Range Output 1: 1.5V~30V ,(Step-up DC/DC Controller),Can be set freely with 0.9V(+-2.0%) of reference voltage supply & external components
Output 2: -30V ~ 0V ,(Inverting DC/DC Controller),Can be set freely with 0.9V(+-20mV) of reference voltage & external components
Output Current Output 1 : more than 20mA (VIN=3.3V,VOUT=15V) ,Output 2 : more than -20mA (VIN=3.3V,VOUT=-7V)
Soft-Start Internally Set-Up
Stand-by Current 3.0μA(MAX)
Power Supply Voltage Range 2.0V~10V
Oscillation Frequency 180kHz±15%, 300kHz、500kHz are available as custom

Packages

Package USP-10 Number of Pins 10
Pcs/Reel 3,000 Package Size(mm) 2.5 x 2.7 x 0.6

DATA SHEET

Quality Reports

FAQ

QuestionWhat does the standby mode mean in the case of the multi channel IC?
Answer

It means the state where the entire IC has been turned off. For Torex products, it means that the pin voltages of EN1 and EN2 are both 0V.

QuestionHow does the GO function of DC/DC converters work? Does it work just like a regulator?
Answer

Torex regard the PWM/PFM automatic switch control function as Green Operation (GO) in the case of DC/DC. The GO function is defined as the switching operation between the PFM mode for a small output current and the PWM mode for a large output current. The PFM control method controls the output current by increasing and decreasing the fall time according to the output current while keeping a pulse width. The PWM control method controls the output current by adjusting the pulse width of the rise time, which keeps the rise/fall time interval constant and increases the efficiency at a heavy load. By switching between the PFM control for a small output current and the PWM control for a large output current, the quiescent current can be controlled for both of heavy and light loads.

QuestionWhat is the soft-start function?
Answer

The function to soften the rise to prevent the inrush current.

QuestionWhat is the standby current?
Answer

The current that flows through the IC in the standby mode. The standby mode means the state where the IC has been turned off by the CE function.

Close