XC6227 Series

700mA High Speed LDO Regulator with Reverse Current Protection

The XC6227 series is a highly accurate, low noise, high ripple rejection, low dropout, and low power consumption high speed voltage regulator. The series consists of a voltage reference, an error amplifier, a driver transistor, a current limiter, a thermal protection circuit, a reverse current protection circuit and a phase compensation circuit.

The CE function enables the entire circuit to be placed in a stand-by state by inputting a low level signal to the CE pin. Over-current protection and thermal protection circuits are integrated. The protection circuit starts to operate when either output current reaches the current limit level or junction temperature reaches the temperature limit. With the reverse current protection function of a driver transistor, the reverse current flow is prohibited when VOUT voltage is higher than VIN voltage. For an example, when a battery is connected to the VOUT pin, battery current will not flow back to the XC6227.

Typical Application Circuit


MaximumOutput Current 700mA
Dropout Voltage 120mV@IOUT=300mA(VOUT=3.0V)
Operating Voltage Range 1.7V~6.0V
Output Voltage Range 0.8V~5.0V
High Accuracy ±1%(VOUT>2.0V)±0.02V(VOUT≦2.0V)
Low Quiescent Current 100μA
CE Function Active High、Stand-by Current Lsee than 0.1μA
High Ripple Rejection 65dB@1kHz
Operating Ambient Temperature -40℃~85℃
Low ESR Capacitor Low ESR Ceramic
Environmentally Friendly EU RoHS compliant, Pb free



Technical Document

Quality Reports


QuestionWhat is the standby current?

The current that flows through the IC in the standby mode. The standby mode means the state where the IC has been turned off by the CE function.